The No. 8 punch has a capacity of a 1/4″ hole through 1/4″ plate. Unlike other similar tools, this punch will punch and strip inside a 90° arc movement of the lever and the upper handle will not disengage when moved to either extreme. Includes one 9/32″ round punch and die set.
Options include a bench mounting base, with a 3″ – 3″ 3/4″ x 5″ tapped base table; and a factory reversal of the upper handle to provide front pull-down operation when the tool’s intended use is as a bench mounted unit.
The No. 20CTL punch offers 20 tons of punching power to meet heavier job requirements, and greater versatility in punching flat sheets and angles. Includes one 1/2″ round punch and die set.
No. 20 and No. CTL20 are similar, except that the frame around the die pocket of the CTL20 is machined to allow punching close to the web of angle iron (9/16″ from web to center of hole).
Options for these tools include a ratchet attachment (for No. 20 and No. CTL20) to permit operation in close quarters and a pipe handle to provide adequate leverage with minimal effort.